The switch (cod. 052) is the ON/OFF control that powers up and shuts down RGV Ausonia series slicers. It is the button that starts and stops the motor: press it once to run the blade, press it again and the machine turns off. This replacement part fits the RGV Ausonia 190 and Ausonia 220 models, as well as the Mary 220 Silver, which uses the same control assembly.

If the slicer will not switch on even though it is plugged in, does not turn off when you press the button, or starts and stops intermittently with a 'flickering' contact, the switch is almost always the part to replace: the internal contacts wear out and no longer close the circuit reliably.

Safety note: as an electrical component, replacement must be carried out by a qualified technician, with the slicer switched off and the plug disconnected from the mains socket.